If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I have built several, but cannot tell you where the problem is with so little details.
Do you have a scope?
Which version did you build?
Don
yes got scop 20 Mhz the tarsus working nicly but withe big things like coc & pepsis tins the osilator wave Rx13.071khz and TX12.500 kHz
with out Auto tune see the Atachment
yes got scop 20 Mhz the tarsus working nicly but withe big things like coc & pepsis tins the osilator wave Rx13.071khz and TX12.500 kHz
with out Auto tune see the Atachment
Is disc working? Can you accept silver and reject iron?
More importantly, can you reject ferrite and accept all metals? (the only practical way to use this device).
Is disc working? Can you accept silver and reject iron?
More importantly, can you reject ferrite and accept all metals? (the only practical way to use this device).
This will tell us if you have the phasing right.
hay dfbowers its ditect all metalls not rejecting any metal iron steel and silver avery thing coin size ditect between 1to 2 cm only not more i mean the distance not size of coin and every thing woking all varibal resistans disc and tune vol all ok and folwed RX with alumnim I checked its conecty from side to side with multi meter if it broken or not all ok
thanks and sorry for disturb
see my tarsus in yutobe:http://www.youtube.com/watch?v=qOBCN...ature=youtu.be
hay dfbowers its ditect all metalls not rejecting any metal iron steel and silver avery thing coin size ditect between 1to 2 cm only not more i mean the distance not size of coin and every thing woking all varibal resistans disc and tune vol all ok and folwed RX with alumnim I checked its conecty from side to side with multi meter if it broken or not all ok
thanks and sorry for disturb
see my tarsus in yutobe:http://www.youtube.com/watch?v=qOBCN...ature=youtu.be
Oh my... you should be detecting even tiny coins at 25cm.
To start with, check all voltages. Do you have the correct voltages to your ICs?
Also, be aware that there was a mistake in one of the schematics.
How does your coil null look? What is the residual voltage on your Rx coil?
What is the peak voltage across your TX coil?
What version did you build? There is one version with a self adjusting threshold and one without. Had trouble with one version with SAT.
Don
Oh my... you should be detecting even tiny coins at 25cm.
To start with, check all voltages. Do you have the correct voltages to your ICs?
Also, be aware that there was a mistake in one of the schematics.
How does your coil null look? What is the residual voltage on your Rx coil?
What is the peak voltage across your TX coil?
What version did you build? There is one version with a self adjusting threshold and one without. Had trouble with one version with SAT.
Don
TX ACV 18 Frq=12.500 KHz
RX ACV 0.28 Frq= 13.5 KHz
and the capasitor is there C20 =100nF see scham diagram
Igot some thing in my mind
Idont think its any problem if Im using hi Impedance speaker 72.5 Oms?
hi to all i am make one tarsus is not work just There is no sound headphone Coil disk does not answer to any metal Any solution to the problem of used this image for printing
Comment