These are a cheap fast way of getting a micro interfacing to bulletproof low loss mosfets interfacing into Tx coils.
http://www.hobbyking.com/hobbyking/s...ontroller.html
There is 3 outputs that could do Bipolar Pi coil drives.
A AT mega 8 tiny risc that can be reblown from small round pads on the pcb
they have 10bit a to D on here too and a timer etc.
2 Lipo supply (on board 5v reg)
Just re blow/ configure for part of a det..
S
http://www.hobbyking.com/hobbyking/s...ontroller.html
There is 3 outputs that could do Bipolar Pi coil drives.
A AT mega 8 tiny risc that can be reblown from small round pads on the pcb
they have 10bit a to D on here too and a timer etc.
2 Lipo supply (on board 5v reg)
Just re blow/ configure for part of a det..
S