If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
hi guys this maybe a dumb question but is there any way of running coil calc in reverse ie imputing radius, thickness and inductance and getting no of turns thickness of wire?
thanks aly
hi guys this maybe a dumb question but is there any way of running coil calc in reverse ie imputing radius, thickness and inductance and getting no of turns thickness of wire?
thanks aly
Of course that would be possible, but I've just not got round to modifying the code. At the moment it's quite easy to add or subtract a few turns until you have the required value of inductance.
Comment