Quote:
Originally Posted by Jeg
Hi Jh
Your voltage levels at sensor's output look that they are normal.
Assuming that your circuit is correct, then try the following.
When your voltmeter is connected alter your potentiometer to adjust again the buzzer/led threshold. Normally you will be able again to turn on your led.
Find a way to firm your meter's probes on the right points and then move your hands away to see if there is a variation on numbers. Then attach antenna with your hand and confirm that the output voltage drops down.
In general, device interacts with your body as it uses it to close the circuit between device and earth. Your hand acts as a capacitor plate. When you adjust your device your hand has to be firm and steady attaching the handle of your device or your aluminum box.
Regards
|
Hi Jeg.I am not yet on sensor stage..The voltage I got is from the display circuit,the R10 from ic3a pin3..I will try to finish the sensor stage today..
ps..I do not have voltmeter so I used the 1 led display..
__________________
Ask, and it will be given to you; seek, and you will find; knock, and it will be opened to you...
|