|
#1
|
||||
|
||||
Quote:
|
#2
|
|||
|
|||
The fact that there is a resonant circuit (L1 / C10) implies that in some way the frequency is important and in my opinion there are 2 possibilities, one is that the phenomenon emits in a wide range of frequencies and therefore also in the FM range (about 80 - 110 Mhz), the other possibility is that the phenomenon interferes with the signal emitted by transmitters in this range but in this case the lrl would have to detect this signal source in a directive way, which does not happen.
|
#3
|
|||
|
|||
For so many years, I haven’t seen you make a decent pcb. A decent machine. I haven’t seen you make a video. You don’t even know the value of the inductance. What tuning are you talking about?
|
#4
|
|||
|
|||
In Italy there is a proverb "appearances are deceiving".
|
#5
|
|||
|
|||
Let me tell you the truth, this circuit is made of double-sided copper clad laminate, and the output is only a little bit. When made of single-sided copper clad laminate, the output is more than two volts. It does not matter how much the output is. As long as it can be compared in the end, there is no adjustment for l1 and c10. Meaning, within the range of 100pf, or even greater, its sensitivity has not changed much. It can react to the sky or some ground, but this is only a problem of geographic magnetic field and has nothing to do with metal. Don’t say you succeeded. In fact, no one has ever seen you, nor can you know that you succeeded or failed. You always like to hear others say that you succeeded, and you hate others to say no. This is your psychological problem. You found water at a depth of 60 meters in your country. The basic knowledge tells you that as long as it is not a mountain, there is basically water in the ground 60 meters deep. You attribute this function to the oc
|
#6
|
|||
|
|||
All forum members will take note of your opinion, as far as I'm concerned I have nothing more to say to you.
|
#7
|
||||
|
||||
Hello Franco
You write: We cannot use an oscilloscope for measurements in the sensor stage and for the adjustment need only one voltmeter is required to connect to the output of the filter R16, C18 without the use of the oscillator. If we have 2-4volts DC output, this means that the sensor stage is working properly without oscillations. But .... we can have oscillation, because a voltmeter can not show it and let us have an output in the range 2-4v DC My question. Can we use the oscilloscope to properly adjust the trimmer on the TR3 emitter or is it practically setting in the field? Please explain more Thank you
__________________
|
#8
|
|||
|
|||
Quote:
|
#9
|
||||
|
||||
hi franco
thank you so much for sharing this circuit i made several time your lrl that is work perfect best regard zakari |
|
|