Lrl from Italy

[taxma1981]

Hi franko and thanks for the bmw lrl haha,it is work very fine

https://youtu.be/E6GMjF44hNM

[indiana jones]

Hi franko and thanks for the bmw lrl haha,it is work very fine
https://youtu.be/E6GMjF44hNM

Nice work Aki.

BMW
Bayerischer Mist Werke

[taxma1981]

Nice work Aki.

BMW
Bayerischer Mist Werke

:χαχαχα::χαχαχα: indiana das ist deine plakette

[enjoykin4]

Hello Taxma1981

Can you share with all here - oscillographs from your working PLL4046 LRL from the most important points like GEO did and also pictures of your PCB ??

Best Regards
Enjoykin4

[taxma1981]

The board is from Indiana, only indiana has a pcb

[taxma1981]

One more test,this lrl work perfekt

https://youtu.be/4nGxc7xCLOg

[enjoykin4]

taxma1981 PROVE your PLL4046 LRL is working ??

Go to the test field and dig up some golden coins ??

Regards
Enjoykin4

[enjoykin4]

OK folks let's open the cards !!




Dear signore FrancoItaly Phantom LRL and PLL4046 LRL are working but ...... one no !!

It is extremely difficult - near critic to adjust properly work and tune it to catch gold and silver frequencies !!

In my oppinion problem is in extremely sharp slope of capacitance to voltage convertor - couple of hundred femtofarads for full scale output voltage 6V DC..

This "Scalar phenomenon" boost the output voltage - it means we need to tune positive feedback between "Golden signal" and signore Franco LRL's,

How to boost maximum sensitivity ??

When we touch tha antenna with bare hand(s) voltage must drop immediately to 0V (zero volts). It means that capacitive coupling between primary oscillating circuit - antenna with coil L1 and capacitor 22 pf in parallel to coil with internal oscillaor (8MHz or 3MHzPLL) must be couple of hundred femtofarads. Also peak to peak sinusoidal voltage of internal oscillator must not be to high - not higher than 1Vpp (1Volt peak positive to 1Volt peak negative sinus).

Scalar phenomenon (read Golden signal) increase capacitive coupling between antenna-L1C1 and several serial capacitors 1pf connectd to internal LRL oscillator (8MHz or 3MHzPLL) up to tenth picofarads which make shunt (in parallel) over several serial 1pf capacitors so the great ammount of RMS RF power comes to base of second transistor T2 and after additional amplification, rectification and filtering we got a pure 6V DC voltage at output. The key for detecting phenomenon is influence of Scalar signal to several capacitors. On some way their capacitance rise to ten or maybe hundred times higher value than inicial but only while Scalar signal make longitudinal transient through.

I dont think transistor T2 is key to reveal scalar phenomenon but spatial relationship between antenna-primary coil L1C1-several coupling capacitors and internal oscillator. It is like Scalar signal make tunneling of main oscillator signal and in same time boost him to high amplitude.

I think it is a crucial thing makeing PCB exactly like signore Franco did and start fighting with "phantom" capacitive feedback.

Also check your LRL - it must be insensitive to ground (not rise and not drop output voltage).

Best Regards from Russia
Enjoykin4

[FrancoItaly]

Hi enjoykin4,
Only one of my 10 lrls worked bad (quartz lrl) and I don't understand the cause, the pcb was the same and also the components. Probably parasitic couplings were the cause, we must not forget that the my first lrl was a rf sniffer that went to autoscillate. We must also remember that there is a base/emitter capacitance (TR2 and all BC... transistors) of about 10pF that is in parallel with 22pF capacitor, if we take away 22Pf capacitor the lrl works well anyway. You're right "peak to peak sinusoidal voltage of internal oscillator must not be to high - not higher than 1Vpp (1Volt peak positive to 1Volt peak negative sinus)." this is why quartz LRL is easier to develop, indeed the oscillator output is few volts peak to peak.
Best Regards

[enjoykin4]

Thank you signore Franco !!

Best regards
enjoykin4

[enjoykin4]

FrancoItaly Hello !!

Do you have spare time for additional experiments in your laboratory with your LRLs.
Want to help to try catch "Scalar phenomenon".

Knowing that scalar longitudinal wave running through copper conductor changing polarity at exact same distance (for example at every 40 cm) - already checked with compass running HV scalar phenomenon (induced type) , you can try to build kind of scalar detector in form of Rogowski current sensor using toroidal type windings and make realtime recording using your frontend digital sempling oscillograph (Le Croy type I guess ??) as a real time recorder. It is very useful to make in same time wide band spectra recording in near field using independent spectral analyser and stylus antenna at input.

Something similar did Esteban in 2010 and much earlier in 1970th Professor Gennadiy Vasilevitch Nikolaev in his Tomsk Laboratory.



You shoud to know that when toroidal core with radial winding excited at proper way doesnt catch transversal (vector type) EM waves - because they all are closed (concentrated) in interior structure of toroid while in same time longitudinal scalar wave (both polarity [plus,minus] has maximum amplitude in axial axis of toroid coil. These all means you need additional pair of windings (perpendicular to radial [vector windings]) to catch scalar longitudinal wave while running through stylus antenna.

It semms to me you are only person and only HUMAN here who want to cooperate and share your great knowledge and experience in contrary to some persons who give nothing but only catch informations for own "slavery glory" and polite and nice words from their bosses in secret services and all other "spy agencies".

Yes my dear frioend Franco it is VERY HARD to be a HUMAN like YOU and very easy to be @slave specialists for LRLs@ like many on this forum.

Rogowski Coil

http://en.academic.ru/dic.nsf/enwiki/148752

Rogowski Coil

https://en.wikipedia.org/wiki/Rogowski_coil

Rogowski Coil Construction

http://electrical-engineering-portal.com/rogowski-coil-construction

Rogowski and Current Measurement

http://www.pemuk.com

Rogowski Coil sensor

http://www.powertekuk.com/cwtmini.htm

key words:

http://www.nigma.ru/?s=rogowski+coil+how+to+make&t=web&rg=t%3D%D0%9A%D1%83%D1%80%D1%81%D0%BA_c%3D%D0%A0%D0%BE%D1%81%D1%81%D0%B8%D1%8F_&rg_view=%D0%9A%D1%83%D1%80%D1%81%D0%BA%D0%B5&yn=1&gl=1&rm=1&ms=1&yh=1&av=1&nm=1&lang=all&srt=0&sf=1

.................................................. ......................


Be health and in good will !!!!
Best regards from me
Enjoykin4

[enjoykin4]

Signore Franco maybe I am wrong ??

Maybe is not a good idea to share my knowledge and experience in Physics but put rose googles at my eyes and look on this shiny, perfectly, nice ROSE WORLD - and this PARASITIC CIVILIZATION (of SATANIC JEWISH TYPE) in all rose colours - like many do ??


what a shiny happy people ! ........


PS: This is a question i still have not answered yourself.....

[FrancoItaly]

Hi enjoykin4,
Unfortunately I'm away from my laboratory, I have to watch my wife here and I have no electronic instrument, only a tester. I own a digital and an analog oscilloscope and many electronic components but unfortunately they are in Italy. I think that's always a good idea to share knowledge and experience, it's the only way to progress. I thought a lot before posting my LRL on the forum, but then I felt it was the best and I would have got benefits too. I wanted to confirm the proper functioning and maybe someone might improve it. I have helped many people privately with email and one confirmed to me a very good find, and this made me very happy. This was the only way to keep alive the forum. First it was a long series of disputes between believed in the phenomenon and others who ironically also denied the existence of the phenomenon. I now believe that there are no doubts about the existence of the phenomenon and the ability to reveal it. I really appreciate your suggestions but at the moment I can not deepen them. I am interested in the use of infrared to increase the performance of the LRL, to obtain discrimination and for the operation even with fresh buried gold.
Best Regards

[enjoykin4]

Thank you Signore Franco !!

Best regards !
enjoykin4

[enjoykin4]

Hi enjoykin4,
Unfortunately I'm away from my laboratory, I have to watch my wife here and I have no electronic instrument, only a tester. I own a digital and an analog oscilloscope and many electronic components but unfortunately they are in Italy. I think that's always a good idea to share knowledge and experience, it's the only way to progress. I thought a lot before posting my LRL on the forum, but then I felt it was the best and I would have got benefits too. I wanted to confirm the proper functioning and maybe someone might improve it. I have helped many people privately with email and one confirmed to me a very good find, and this made me very happy. This was the only way to keep alive the forum. First it was a long series of disputes between believed in the phenomenon and others who ironically also denied the existence of the phenomenon. I now believe that there are no doubts about the existence of the phenomenon and the ability to reveal it. I really appreciate your suggestions but at the moment I can not deepen them. I am interested in the use of infrared to increase the performance of the LRL, to obtain discrimination and for the operation even with fresh buried gold.
Best Regards

CIAO SIGNORE FRANCO

How do you do - and our wife to ?

To obtain discrimination with our LRL's make experiments with variabile pulse trains. As you well know like 50 years experienced electronic constructor - simple single pulse have infinite series of sinus (or cosinus) frequencies - and theoreticaly has an infinite power.

Remember the Great Nikolai Tesla work. He has used very high amplitde more than 12 000 000 Volts and extremelly sharp nano (or pico) impulses to excite etherical froces in his Magnificient Collorado-Springs transmitter. And he got the results.

I think that golden signals are part of this etherical force which influent classical EM-field so the reulsts can be obtained with much lower amplitudes. Remember Mineoro golden-cells cavities - in fact cylindrical capacitors because Maxwell displacement currents in non-polarised capacitors are nothing less or more to tha longitudinal scalar waves which are not electromagnetic in nature. Capacitor is a kind of conversion tube between those two natural filelds.

If you are interested in modulation signal envelopes - feel free to contact me at email
enjokin4@yandex.ru

ps: I think it is no sense to public here many thinks i know because many people here has not pure and clean intention.

Best regards
enjokin4