The detection is made with c1 and c2. It detects the what was known as ground balance in the old detectors. There is a simpler circuit on the web which just uses the op amp but this is still a good circuit and the cmos chip may give the circuit a good input impedance.
tank you aft-72005 and dedevil
Who knows the device based on this model?
Systems companies vector track For example pdf1000
A probe is connected to ground and a telescopic antenna in the air.
How do these systems is based?
The deception ma330!!!
If you did not regret the money, or if you have one too, then just buy this device!
With it you will discover one big NOTHING!
Except if you were not born dowser (as he likes to say our WM6).
Regards!
Sneshko
The deception ma330!!!
If you did not regret the money, or if you have one too, then just buy this device!
With it you will discover one big NOTHING!
Except if you were not born dowser (as he likes to say our WM6).
Regards!
Sneshko
no Sneshko.I do not want to buy this device.
I just know based on what works.
Who knows?
I understand dininig but cannot understand this device.
1. It's transmitting
2. It's earthed
So it is charging the local area.
When a diviner walks in that area the diviner is also charged with the underground earth from the transmitter which would give no difference in L rod movement.
maybe i am missing something?
regards
hi to all freinds
Can someone explain to me how this circuit works?
How it helps to find gold and silver?By what process?
This circuit does not help you to find gold and silver.
It makes a small signal electricity that does nothing for a treasure.
The signal cannot be measured more than 5 cm distance away from the brass rods that you push into the ground.
The brass ground probe rods can be good to help locate buried metal if you put a rod in the ground to hit against the buried metal.
When you feel the rod push against the metal, you will know you have located treasure under the rod.
Or maybe if you are not lucky, you located a rock.
After thinking about it. There appears to be two types of detection methods used here.
But, there is a part missing in the telescopic antenna. This part gives you the direction to go to and devine with L rods.
rgds
This circuit does not help you to find gold and silver.
It makes a small signal electricity that does nothing for a treasure.
The signal cannot be measured more than 5 cm distance away from the brass rods that you push into the ground.
The brass ground probe rods can be good to help locate buried metal if you put a rod in the ground to hit against the buried metal.
When you feel the rod push against the metal, you will know you have located treasure under the rod.
Or maybe if you are not lucky, you located a rock.
See below the principle of operation for MFD:
Best wishes, J_P
This is a great post JP, most people will understand it and is very true,
Maybe there is still too much text in it but the progress is obvious.
After thinking about it. There appears to be two types of detection methods used here.
But, there is a part missing in the telescopic antenna. This part gives you the direction to go to and devine with L rods.
rgds
"detection method" is a bad word in this forum.
Any device that will randomly do something, is a good candidate to LRL. Your mind will do the rest.
If there is electronic circuits inside you will believe more easily about a possible "method" used, so it will seems to work better, as the base is your belief.
Comment