PDK-2.1 COMPLETE INSTRUCTIONS
That is correct,the VHF waves reinforced the ELECTROMAGNETIC field around buried gold/silver objects.
Also here the old ANALOG TV VHF transmitions stop 24.04.2012,and i note the PDK was not able to pick targets after that,the new DIGITAL UHF TV waves are useless.
But fortunatly i develop some upgrades in the PDK and new calibrations that make the LRL pick the targets again,however the presence of VHF waves are very good for the PDK´s.
Here complete INSTRUCTIONS for the PDK-2.1,that will make you understand how it works.
INSTRUCTIONS :
1-The TUNING knob must be all the time on the triangle mark,is the full power.
2-The FINE TUNING it must be completly to the left position when you switch ON the PDK , and slowly rotate to the right(arrow direction) until start the beeps ALLWAYS in the referenced marked area,in searching mode the knob must be all the time in the reference marks,then you need to calibrate the LRL to the critical point when your finger touch the knob and emit intermitent beeps it means is ready for search,and time to time check with finger if is sensitive,if emit the beeps,sometimes need little adjustments when batteries go low.
Use ALKALINE batteries,or 9V rechargeable,never 10V batt.
The batteries can stay 2 or 3 hours,check the batt. condition by pressing the little knob,while pressing if RED LED stay open it means low batteries,change batteries.
Very important : when the PDK is ON,your MOBILE must be OFF to avoid interference.
If people stay in front of PDK will mask the buried metals PHENOMENON,people must be behind the PDK,when you searching or pinpointing the objects.
CALIBRATION TO LIMIT OF SENSITIVITY :
This calibration must be done far from electrical sources(not possible to make calibration at home becouse of electrical interferences),with one hand in the handle ,(the TUNING knob must be in the TRIANGLE mark) and slowly move the FINE TUNING to the right until the LRL beeps intermitent like a sonar while touching the knob with finger. This way is very sensitive.
If this calibration result with erratic signals,reduce just a bit to the left until is stable.But it must beeps when touching the knob.
Is usefull if you searching in remote areas very far from TV VHF transmitters,where not exist RF electromagnetic waves,so the PDK must stay in top sensitivity to pick the targets.
CALIBRATION TO MINIMUM SENSITIVITY :
This calibration is usefull if you are working not far from VHF TRANSMITTER. The VHF waves increase PDK power in 50% to locate the PHENOMENON(electromagnetic field around buried metal) of GOLD/SILVER buried objects.
Also this calibration is very useful when you searching in places where there is ground or transmitters interferences that make the PDK unstable,using this calibration is very stable,it will emit beeps only for gold or silver metals.
The PDK is tuned with frequency to find only noble metals .
This calibration consist in keep the FINE TUNING knob to emit only one beep when you touch the knob with finger,the capacitance make the circuit to emit ony one beep when PDK is sensitive,or many intermitent beeps(like a sonar) when is very sensitive.
Objects distances and deep :
very old coin - 8 m distance, the maximum reported deep was 60 cm
large object 20X20cm - 80 m distance,the deep can be even more than 5 m.
NOTE:
More time the object is underground,more intensive is the electromagnetic field around object,more distance will be located. Objectes buried less than 20 years ago are not possible to be located.
Searching in fields worked constantly by tractors is not possible to pick targets(electromagnetic field was destroyed) ,however is possible to pick the tagets below the tractors worked area,or places where the ground was not touched.
About the best weather conditions,PDK can be used with all weather conditions except when is raining days, high humidity can damage the circuits or produce interferences.
Originally posted by Goldmaxx
View Post
Also here the old ANALOG TV VHF transmitions stop 24.04.2012,and i note the PDK was not able to pick targets after that,the new DIGITAL UHF TV waves are useless.
But fortunatly i develop some upgrades in the PDK and new calibrations that make the LRL pick the targets again,however the presence of VHF waves are very good for the PDK´s.
Here complete INSTRUCTIONS for the PDK-2.1,that will make you understand how it works.
INSTRUCTIONS :
1-The TUNING knob must be all the time on the triangle mark,is the full power.
2-The FINE TUNING it must be completly to the left position when you switch ON the PDK , and slowly rotate to the right(arrow direction) until start the beeps ALLWAYS in the referenced marked area,in searching mode the knob must be all the time in the reference marks,then you need to calibrate the LRL to the critical point when your finger touch the knob and emit intermitent beeps it means is ready for search,and time to time check with finger if is sensitive,if emit the beeps,sometimes need little adjustments when batteries go low.
Use ALKALINE batteries,or 9V rechargeable,never 10V batt.
The batteries can stay 2 or 3 hours,check the batt. condition by pressing the little knob,while pressing if RED LED stay open it means low batteries,change batteries.
Very important : when the PDK is ON,your MOBILE must be OFF to avoid interference.
If people stay in front of PDK will mask the buried metals PHENOMENON,people must be behind the PDK,when you searching or pinpointing the objects.
CALIBRATION TO LIMIT OF SENSITIVITY :
This calibration must be done far from electrical sources(not possible to make calibration at home becouse of electrical interferences),with one hand in the handle ,(the TUNING knob must be in the TRIANGLE mark) and slowly move the FINE TUNING to the right until the LRL beeps intermitent like a sonar while touching the knob with finger. This way is very sensitive.
If this calibration result with erratic signals,reduce just a bit to the left until is stable.But it must beeps when touching the knob.
Is usefull if you searching in remote areas very far from TV VHF transmitters,where not exist RF electromagnetic waves,so the PDK must stay in top sensitivity to pick the targets.
CALIBRATION TO MINIMUM SENSITIVITY :
This calibration is usefull if you are working not far from VHF TRANSMITTER. The VHF waves increase PDK power in 50% to locate the PHENOMENON(electromagnetic field around buried metal) of GOLD/SILVER buried objects.
Also this calibration is very useful when you searching in places where there is ground or transmitters interferences that make the PDK unstable,using this calibration is very stable,it will emit beeps only for gold or silver metals.
The PDK is tuned with frequency to find only noble metals .
This calibration consist in keep the FINE TUNING knob to emit only one beep when you touch the knob with finger,the capacitance make the circuit to emit ony one beep when PDK is sensitive,or many intermitent beeps(like a sonar) when is very sensitive.
Objects distances and deep :
very old coin - 8 m distance, the maximum reported deep was 60 cm
large object 20X20cm - 80 m distance,the deep can be even more than 5 m.
NOTE:
More time the object is underground,more intensive is the electromagnetic field around object,more distance will be located. Objectes buried less than 20 years ago are not possible to be located.
Searching in fields worked constantly by tractors is not possible to pick targets(electromagnetic field was destroyed) ,however is possible to pick the tagets below the tractors worked area,or places where the ground was not touched.
About the best weather conditions,PDK can be used with all weather conditions except when is raining days, high humidity can damage the circuits or produce interferences.






Comment