Magnacast 5000

[Mike(Mont)]

Just so everyone knows, it was not working when I tried it today. It just wasn't locking on to the test target. I didn't wait fifteen minutes like the instructions say, didn't wait at all, so maybe that was part of it. It was cold, too.

Also, I thought I was running at "4" power setting the other day, but I looked at the dial and it was set on "3". I tried "4" the other day after I made that post and it was too much. I could not isolate the target from the other noise.

[Mike(Mont)]

Installed a new trim pot today. It did not help very much. Obviously I don't have much electronics knowledge. I suspect I need I different value capacitor, but I did order a precision pot and I'll try that.

[Mike(Mont)]

I got the precision pot, replaced one of the trim pots with it so it is outside case and it helped. So now I have one channel that is adjustable frequency. I just have to carry a frequency counter with me. It's still pretty touchy and the freq bounces about a tenth of a hertz. The weather is cold and windy today so I didn't get much time to work with it but it should work okay.

[Napsterce]

Any news with this?

[Mike(Mont)]

Haven't done anything with it except a new battery. Think I even salvag d the pot for another project.

[Napsterce]

Mike do you have the schematic from the unit?

[Mike(Mont)]

Long answer, no.

[Mike(Mont)]

This thread is ten years old. Wish I could say I am richer. Sure feel older.

[Agraz]

someone already has a diagram of magnacast 2000 or 5000, it seems that no longer exists the company Vernell electronics.