Lrl from Italy

[FrancoItaly]

Hi WM6,

I agree with you, wood is poor insulator and poor electrical conductor, but with the aluminum shield I think that you can use. I prefer to use plastic panels that I find with ease.

Best regards

[brs]

HI franco

More sensitive L1 8turen

[brs]

http://cdn.top4top.net/i_50a7c8466d1.jpg

[FrancoItaly]

HI brs,
This is my lrl? What is the coil in the upper side of the box?
Best Regards

[mustefa ubram]

franco in your lrl with 8mhz frq and cap 22p The inductance L1 is about 180 Nanohenries ?true?
http://chemelec.com/Calculators/LC-Calculator.htm

[brs]

Hi Franco
This two in one device below the passive receiver only of Andreas and the top of your device

[brs]

TV almost 5meters led first Lights
two meters led first and led The second lights
After the one-meterThree lights on.
Sorry Translator Use

[brs]

Is it true Francoa amendments
P1= 10k
P2= 680k
L1 = 8 turen wire ,50mm

[FrancoItaly]

Hi Mustefa,

these data are ok.

Best Regards

[FrancoItaly]

Hi brs,
I will try the coil with 8 turns but with 3 turns and up to 100pF for the capacitor I had no results. Probably every country requires a particular frequency.
Best Regards

[Bill512]

Franco 4046

Hi Franco, this is my version of your LRL ,the one with the 4046.
First of all, I want to say a big thanks to you, for sharing these schematics.
I don't know if these LRL actually working, but I strongly believe that you believe in these.
And this matters, sharing with everyone in this forum, something personally precious.
This ,at my opinion ,is the true spirit of collaboration in this forum.
Thanks again.
Bill

[FrancoItaly]

Hi Bill512,
Good work, I want to add that in this LRL can be added also the measure of the signal amplitude as in the LRL with quartz at 8MHz, in fact the amplifier is the same in the two cases. I have done this in a particular LRL to see if there were differences between the various metals by comparing measurements of phase and amplitude, but it seems that there is no difference.
Regards

[daniel]

Hi there

do someone have a PCB preferably in black and white from the LRL from post 68 ?

thanks very much

[Bill512]

Hi Bill512,
Good work, I want to add that in this LRL can be added also the measure of the signal amplitude as in the LRL with quartz at 8MHz, in fact the amplifier is the same in the two cases. I have done this in a particular LRL to see if there were differences between the various metals by comparing measurements of phase and amplitude, but it seems that there is no difference.
Regards

Hi Franco,
while playing around with the FrancoPPL, I noticed that close to power sources or close to "potencial anomalies from buried metals", the Led goes off.
The same happens in the voltage at pin 1 of the LM358.
Is this normal? or maybe there is some mistake in my PCB?
regards

[Geo]

Hi Franco, this is my version of your LRL ,the one with the 4046.
First of all, I want to say a big thanks to you, for sharing these schematics.
I don't know if these LRL actually working, but I strongly believe that you believe in these.
And this matters, sharing with everyone in this forum, something personally precious.
This ,at my opinion ,is the true spirit of collaboration in this forum.
Thanks again.
Bill

Hey Bill artist....