Lrl from Italy

[darkman]

Mr franco:
tr1 emitter = 4.83 v
tr2 collector = 5.59 v (with full led on when i check it)
tr3 collector = 5.22 v (with full led on when i check it)
tr4 collector = 5.84 v .
tr5 emitter = 0.30 v (for 1 sec ) then = 0 v .
all volts is dc-volt
note : C15: in= 5.84 , out= 0 to 0.12 v .
i try every thing to make the output more than 0 v .
what do you think ?
regards

[FrancoItaly]

Hi darkman,
The DC voltage of TR1, TR2, TR3 and TR4 are appropriate, you have to check if the stage of TR1 oscillates, for that you need an oscilloscope at TR1 emitter. If you do not have a scope you can disconnect a terminal of C15 from TR4 collector to TR1 emitter and check if the TR5 emitter is in 1 - 5V DC range. If the TR1 stage does not oscillate you have to increase the value of C1 to 390 pF or 470 pF or 560pF. If the stage of TR1 oscillates in place of C2, C3 and C4 using a 1pF capacitor or 2pF. IF the DC output is still 0V you have to increase C13 and/or C14 using 560-680-820pf or more. I hope to be as helpful.

[putrechigi]

hi

you are greet!!!!

Dear FrancoItaly

I have sent this message to you here only because i coudn't send private mail because:

Quote:

"enjoykin4, you do not have permission to access this page. This could be due to one of several reasons:

1. Your user account may not have sufficient privileges to access this page. Are you trying to edit someone else's post, access administrative features or some other privileged system?
2. If you are trying to post, the administrator may have disabled your account, or it may be awaiting activation."

so i am writing here.
............................

I am sorry about your wife is not in good healt. I think i can help you - even if your wife is in last stage of illness.

Currently in Russia exist one very special healing device - special healing technology which name is СВЕТЛ - in translation it means LIGHT, which already has helped many people to get their good health back. It is very special device and vey special cosmic technology of Russian academician - nuclear physicist Nikolai Viktorovitch Levashov (1961-2012).

His official site
http://lлевашов.рф

http://levashov.ws

Don't trust any lies from any internet source about him (soon one day , you will know why) , and his wife Svetlana (1964-2010) and his/her healing technology. My only advice - try it- try this device SVETL and see healing influence at your wifes life. This device is 30 century technology and i am not a lier about it. I am an physicist not seller or shop assistant. I just want to help you and your wife informing you about.


Russian academician Nikolai Viktorovitch Levashov


Duchess Svetlana Levashova De Roghan Obolenskaya

One short journey to Sank Peterburg will forever change both of yours life at good.
I advice personal reception and contact with RNTO team - Russian Science Technical Society.

For more information contact mail at Russia.


телефон: +7-916-612-19-83
электронная почта: support@svetl.org
Aдpeс: rnto@mail.ru

http://rnto.club/

http://rnto.club/kontakti.html

ps: Quote D'Arsonval: «Anything is possible. But one must not accept anything , except that which can be experimentally
proved. The ideas of an insane person differs from the conceptions of a genious , mainly because experiment invalidates the former and confirms the latter.»

Volhv Enjoykin4 «In quantum physics - there is no difference between Magic and anisotropic realities. Life is Magic and Magic is Life. There is only real light AR RA and real darkness MAR RA».

Good luck
Reg. Enjoykin4

[edwgold]

Ok Mr.Franco - I understand.

I have had good intention to share my knowledge and experience about Scalar physics - but as nobody interested it makes no sense posting additional informations.

So folks good luck to all - you need it for finding a lot of gold.

Best wishes to all
Enjoykin4 - няш-мяш !!

Hi Enjoykin4,

You say that gold can be detected through scalar waves. As it would be the method?

[darkman]

Hi darkman,
The DC voltage of TR1, TR2, TR3 and TR4 are appropriate, you have to check if the stage of TR1 oscillates, for that you need an oscilloscope at TR1 emitter. If you do not have a scope you can disconnect a terminal of C15 from TR4 collector to TR1 emitter and check if the TR5 emitter is in 1 - 5V DC range. If the TR1 stage does not oscillate you have to increase the value of C1 to 390 pF or 470 pF or 560pF. If the stage of TR1 oscillates in place of C2, C3 and C4 using a 1pF capacitor or 2pF. IF the DC output is still 0V you have to increase C13 and/or C14 using 560-680-820pf or more. I hope to be as helpful.

thx Mr Franco .
i am using 2pF capacitor on (C2,3,4) , and C13 and C14 = 1nf , and it work's i got 2 vdc on output .
but when i touch the antenna the volt's drop Up ! and all led's on ?!
regards

[FrancoItaly]

Hi darkman,
I think that isn't important if voltage drops up or drops down, this is only a way for testing the lrl empirically, in this way we are sure that the gain is correct (not too low and not too high to saturate). Now you have to try it on the test field.
Regards

[darkman]

Hi darkman,
I think that isn't important if voltage drops up or drops down, this is only a way for testing the lrl empirically, in this way we are sure that the gain is correct (not too low and not too high to saturate). Now you have to try it on the test field.
Regards

thank you Mr franco

i will try it on test field next week and back with The result , i have 2kg of copper 40cm depth .. 4 month long
Regards

[abdou2014]

HELLO FRANCO . YOU TOLD . IF WE WANT KNOW IF YOUR LRL WORK WELL . THE LED MUST BE OFF WHEN WE PUT OUR HAND NEAR THE ANTENNA . SO WHEN WE ARE OUTSIDE NEAR THE TARGET WHAT WILL HAPPEN TO LED. ON TO OFF OR OFF TO ON ???

[FrancoItaly]

With target the led goes on.

[abdou2014]

Hi Mr FRANCO. THANKS FOR REPLY . I FOUND TARGET WITH GG 918 AND WHEN I TRY TO CONFIRM IT WITH YOUR LRL NOT WORK .

[FrancoItaly]

I never tried the GG 918 but it is possible that the sensor stage of my lrl does not have enough gain, if this is the case it is necessary to increase the gain of the next stage; if you've made a version with 1 LED should be reduced R10, from 220K to 68K or 47K. If you have made a version with 3 LEDs must be increased R2 from 220K to 560K and decrease R1 from 150K to 47K. The sensitivity also increases extending the antenna from about 30 cm to 50-60cm or more. It is also possible that the LRL works in reverse way, that is, the signal decreases in the presence of the target. To check this you have to adjust the threshold in order to have the first LED just turned on and verify if the LRL will switch off in the presence of the target.

[abdou2014]

thanks Mr Franco . you told ( It is also possible that the LRL works in reverse way )
so, how reverse it . and make it correct .

[FrancoItaly]

Many wishes for a Happy New Year to all the members of this forum. We all hope to find a treasure, but the biggest treasure is health although a treasure (even small) can help your health!

[enjoykin4]

to all !!

Happy New 7524 year (counting from ancient Grande TarhTaria victory agains Chinese empire 7524 years ago, or C.M.З.Х in Russian ancient calendar (Koladi dar). Grande Tarhtaria had been destoyed before something more of 200 years ago by Thermo-Nuclear bombs of Koscheys (masters of the "Grays"). Koscheys are Cosmic Parasites (dark forces of Universe) or Cosmic Evil race ( not humanod) and complete mankind past (not history @HIS TORAH@) had been rewritten to help Jewsih Illuminati Cabal (Planetary Social Parasites) to conquere and enslave human race and destroy mankind according to wishes and orders of their evil @Cosmic fathers@.

Yes folks this is a TRUTH. Complete mankind past is upside down !!



Signore Franco !!
Many good health and long life you and your wife and yours family and also best wishes to all members of LRL-forum.

With respect
Enjoykin4 !!

Всем удачи !!

[enjoykin4]

http://tesla.zabotavdome.ru



Some tips and tricks about Scalar Magnetic Field (only for experimenters) !!

Very simple representation of S and V fields.

a) Scalar Longitudinal wave transmmision.
b) Vector Transversal wave transmission.



Scalar Magnetic Field show yourself (can be detectable) only in case of resonance oscillating electronic circuit with bucking coils (partnered) configuration. For example it is famous Nikolai Tesla bifilar configuration which is pure scalar coil configuration.



Nikolai Tesla bifilar coil. (dont forget to put it in resonance)

Signore Franco configuraton is same bucking configuration because his stylus (or coil) antenna together with parallel oscillating circuit L1C1 can be represented like partnered bucking configuration. Imagine stylus (or coil) antenna like may lumped parallel oscillating circuits, conected serially with own resonant frequency.



Yellow trace - resonance of bifilar winding 34.298 KHz.
Blue trace - inductor resonanace (excitation coil) 41.6KHz.
Strange Phase Shift at 41.120KHz.

To get proper resonancematching - the rule is simple - Frequency of excitation coil (inductor) should be exactly resonant frequency of bifilar coil. Anomaly - any active resistance connected at bifilar coil does not change amplitude of source signal (generator or inductor coil). It means - any LOAD does not influent SOURCE. There is ZERO (0) coupling LOAD->SOURCE or simple you have got unipolar feedback. It means you dont waste energy from the source - only change phase shift of source signal. Taking in account Scalar Waves and GOLD-SILVER-COPPER.... it means you can passive sniff precious metals (long time in ground) only tracking phase shift change which they make - making proper scalar field range of actions.

more informations and many interesting links about Scalar waves here:

http://tesla.zabotavdome.ru

• Томилин А.К. О Свойства векторного электродинамического потенциала
• Стефан Маринов
• Униполярный генератор Тесла.
• Диалоги о науке. ЭРГЕНТОР
• Г. Т. Касьянов "УСКОРИТЕЛЬ ЭЛЕКТРОНОВ"(Проверить)
• Первеев Г.П.
• Соединение обмоток трансформаторов
• Калькулятор. Заряд конденсатора от источника постоянной ЭДС
• Евгений Михайлович Ефимов. Реализация односторонней индуктивной связи.
• Резонансный усилитель мощности.
• Евгений Михайлович Ефимов. Реализация односторонней индуктивной связи.
• Инвертор реактивной мощности
• А.В.Чернетский Плазменно-вакуумный эффект.
• Патент Клёсова В.А.
• ОЭДС (Проверить)
• Heating device that produces 17 times more heat than the "equivalent" (Проверить)
• Pre zero crossing detection
• Генераторы гармонических сигналов с LTSpice моделям

PS: GO FOR IT - SIGNORE FRANCO SCALAR SNIFFER !! IT WORTH !! CHECKED AND TESTED BY ENJOYKIN4 !!

With respect
enjoykin4 - няш мяш !!