Problem I do not have 1 Pico capacitors
Is there any solution ?
You can make a capacitor of a few picofads by twisting two isolated rigid wires about 5cm long, two ends will be the terminals to be welded and the other two will be unconnected. This is an old trick used by radio amateurs.
By passive receiver I mean that there is no transmitting oscillator. The internal quartz oscillator serves only to provide a kind of carrier which is modulated by the "phenomenon".
Dear Franco, Is this output in the TR2 suitable
I used the device in the field of testing, affected by a piece of silver weighing 20 g, only a meter away
Dear Franco, Is this output in the TR2 suitable
I used the device in the field of testing, affected by a piece of silver weighing 20 g, only a meter away
1 meter for a piece of silver is already a good result, in fact it shows that the phenomenon is detected. I think that the measurements on TR2 are not very reliable and not necessary, the important thing is that there are 4 / 6V on the collector. What is important is to follow the instructions (helps.txt) to get the maximum amplification, then you can act on the display stage to increase the direct current gain.
By passive receiver I mean that there is no transmitting oscillator. The internal quartz oscillator serves only to provide a kind of carrier which is modulated by the "phenomenon".
Hi dear Franco. How do you do ?
In fact carrier wave is not electromagnetic in nature. If it would be electromagnetic every prospector with simple fm radio receiver could easy detect the phenomenon.
Reactance of coupling capacitor at 120MHz is almost 4K, amplitude of sinus signal is in uV range at the base of first transistor. High gain amplifier amplify this tiny oscillating signal and at outpute there must be pure sinus signal with several volts amplitude.
Whole secret is in unknown behaviour of P-N junction of first transistor after illumination by phenomenon signal. On some strange way, phenomenon virtual photon energy make additive to effective coupling oscillator energy, boost his amplitude and in same time make phase shift due to parasitic properties of active circuit components. What is the most strangest about phenomenon it could be detected only at several "holes" in EM spectrum. Thise "holes" are empty parts of spectrum where is no artificial emmision but somehow they are connected with non-uniform distribution of earth virtual photons field and also with earth magnetic field.
In fact carrier wave is not electromagnetic in nature. If it would be electromagnetic every prospector with simple fm radio receiver could easy detect the phenomenon.
Reactance of coupling capacitor at 120MHz is almost 4K, amplitude of sinus signal is in uV range at the base of first transistor. High gain amplifier amplify this tiny oscillating signal and at outpute there must be pure sinus signal with several volts amplitude.
Whole secret is in unknown behaviour of P-N junction of first transistor after illumination by phenomenon signal. On some strange way, phenomenon virtual photon energy make additive to effective coupling oscillator energy, boost his amplitude and in same time make phase shift due to parasitic properties of active circuit components. What is the most strangest about phenomenon it could be detected only at several "holes" in EM spectrum. Thise "holes" are empty parts of spectrum where is no artificial emmision but somehow they are connected with non-uniform distribution of earth virtual photons field and also with earth magnetic field.
I'm pretty well and you? I must admit that after so many years I know very little about the phenomenon, however Esteban said that even a common FM receiver, tuned to no station, would reveal the phenomenon. I agree with you that it's on the basis of TR2 (the mixer stage) that the conversion of the phenomenon takes place.
Comment