Zahori

[shahrayar]

It is better to send waves ? , RF , AM, FM , VLF

[abdou2014]

The world is affected by transmitters of all categories, you have to try to work outside of these inferences ,
for example UHF or INFRARED !!!

[abdou2014]

My UHF LRL does not react to electrical or radio interference

[shahrayar]

[shahrayar]

The LED should be removed, maybe this helps

[abdou2014]

THANK YOU , BUT WITH WHICH CIRCUIT IS USED ? AND WHY WE REMOVE THE LED ?

[shahrayar]

As an incentive, interact with the treasure aura

[nelson]

Saludos desde Chila.

Thanks very much! I expect rapid return!

Regards,

Esteban

Estimado Esteban.
He estado muy alejado del foro por motivos personales y hoy he logrado reconectar al sitio de LRL.
Primero que todo espero te encuentres mejor de salud aunque no te he visto por aqu??.
Bueno estimado Esteban, solo deseo estes mejor y enviarte los mejores deseos al maestro de los LRL.
Saludos desde Chile.

Dear Esteban.
I have been away from the forum for personal reasons and today I managed to reconnect to the LRL site.
First of all, I hope you are in better health even though I haven't seen you here?
Well dear Esteban, I only wish you were better and just want to send you the best wishes to the master of the LRL.
Greetings from Chile.

[QH2520QH2]

[ATTACH]Schematic Prints.pdf[/ATTACH]

[Pahom]

DubZahori is a New Full Differential PikoAmper LRL.
Zin > 10 Giga Ohms.
Values and tuining are secret.

Best wishes
Dubulumach

I was looking at a very familiar scheme, and it was as if I was digging through the archive one to one. So it's not a secret for everyone!

[khuben]

Hi amigos !
It's been many years since I made a zahori and it worked great.
You should know that as a 4066 key I used an old series from the first production.
They had no static electricity protection and came in tinfoil on the terminals.
From the beginning, I did not believe in this type of device - electronic baguettes, but later during the tests, I saw that it worked perfectly.
Where baguettes detected signals, Zahori repeated them, and very categorically.
I'm sorry we didn't dig to see what the signal sources were
We just went out with friends for a sample and we were very impressed.
I did not make the device for me but for my friend and he went abroad to work.
Then I tried to do this again, but without success.
I still think that this 4066 is the reason in it.
I now have double point time and will be turning on the soldering iron for new runs and samples.
I hope I can find some 4066 from the old material without protections on the inputs.
I will share with you later.
All the best to you and dare!
Try and try ... that's how success is achieved!

[Frederick1986]

1/f=t and c/f=m


If it is 50 Hz in one second, then the time of one generated cycle is equal to 0.02. => 1/50=0.02

The speed of light is equal to 300,000 meters per second, denoted by c. If we divide by hertz, its meter will be known. => 300000/50=6 thousand kilo meters

First, the circuit must be blocked and then manipulated. Hertz is equal to km. Kilohertz is equal to meters. A megahertz equals a centimeter and a gigahertz equals a millimeter. That is, we have a direct relationship with the formula.
As the current and voltage increase, the cross section of the wire and the number of turns must change.
These circuits are recreational called lrl, which antenna is related to the wave and it is not possible to install a ten meter antenna. So you need to amplify the circuit to be able to short the antenna. With respect. Frederick ❤

[erfan]

Hi amigos !
It's been many years since I made a zahori and it worked great.
You should know that as a 4066 key I used an old series from the first production.
They had no static electricity protection and came in tinfoil on the terminals.
From the beginning, I did not believe in this type of device - electronic baguettes, but later during the tests, I saw that it worked perfectly.
Where baguettes detected signals, Zahori repeated them, and very categorically.
I'm sorry we didn't dig to see what the signal sources were
We just went out with friends for a sample and we were very impressed.
I did not make the device for me but for my friend and he went abroad to work.
Then I tried to do this again, but without success.
I still think that this 4066 is the reason in it.
I now have double point time and will be turning on the soldering iron for new runs and samples.
I hope I can find some 4066 from the old material without protections on the inputs.
I will share with you later.
All the best to you and dare!
Try and try ... that's how success is achieved!

Dear friend, which zahori schematic did you make?
As you know, zahori circuit has been changed a lot by different people. Which schematic did you make?