Zahori mods. - Some considerations

[Esteban]

Max wrote:

"Oh yeah, like a degauss-coil in a TV set...

BUT THEN PHENOMENON IS MAGNETIC NOW ?

So how an electrometer could detect it ?

AND GOLD ? IS MAGNETIC NOW ?

I remember is just a few diamagnetic !

ALL BS.

ALL STORIES.

ALL FANTASIES.

AND LRL IS JUST ANOTHER SPIT IN THE OCEAN OF HUMAN STUPIDITY."


Just for to notify that also the magnetic field in X point is affected as a coil is affected by a single coin. In small grade for a single coin, more in sites with much metal, magnetic or diamagnetic metals.

Understand?

[Esteban]

Hi Esteban
So the energy is very strong and this is the phenomenon that we must looking for ???????
Regards


The energy is very strong in treasure sites. I can comprobe in one opportunity, without doubdt, with a not very sensitive device.

I build a square aluminium loop, medium size, 60X60 cm, and insert in it a ferrite core with near 30 ohms of resistence, thin wire. Connect to simple electronics. This is only when you're over the treasure or very near of it. So, is a passive absorptive device of energy.


Btw .... do you received an email from me before somo days ago ?????

Ahh!!! You email me to a corporative Outlook email. Soon I'll email you.

Regards

Esteban

[Esteban]

this is possible, input can be overloaded , hi-impedance etc but seems strange that supposed signal from a buried treasure could burn the input stage of any op. amp. !

In open circuit, yes. No in clossed type coils in MD for example. For your information, THIS OCCURS IN OPEN INPUT SYSTEMS.

Have you the minimum of experience in it? Have you build electronic LRL type open base, for example? What do you know about it? Do you are very young?

[Esteban]

Hi esteban,

Is the location where the 3130 burned far away from all electrical noise, or is it close to power lines and microwave transmitters? What was the temperature of the LRL box when it burned? Hot from sun or not very hot?

I try to understand if it is possible the 3130 burned from High temperature or from high power noise source, or if the treasure signal is the reason for the burned IC.

Best wishes,
J_P

Hi J_P,

In my terminology, "burn" means that "input kaputt", no causes by hot, electrical noise, microwave transmitters, power lines. Like the static electricity when destroy mosfet inputs.

[Max]

Max wrote:

"Oh yeah, like a degauss-coil in a TV set...

BUT THEN PHENOMENON IS MAGNETIC NOW ?

So how an electrometer could detect it ?

AND GOLD ? IS MAGNETIC NOW ?

I remember is just a few diamagnetic !

ALL BS.

ALL STORIES.

ALL FANTASIES.

AND LRL IS JUST ANOTHER SPIT IN THE OCEAN OF HUMAN STUPIDITY."


Just for to notify that also the magnetic field in X point is affected as a coil is affected by a single coin. In small grade for a single coin, more in sites with much metal, magnetic or diamagnetic metals.

Understand?

HI Esteban,
"Just for to notify that also the magnetic field in X point is affected as a coil is affected by a single coin. In small grade for a single coin, more in sites with much metal, magnetic or diamagnetic metals."

???

You use an electrometer-like device for AC fields. Cannot see relationships with magnetic field, if any could, and detected (electrical).

If magnetic field is very strong and at hi-freq. (e.g. an hi-freq. transformer) can give such effects on that circuit... but this is not the case.

You could try using a TV... leaving it connected to the AC source in stand-by. The smps transformer will be detected from meters away, as you know.

Same e.g. for corona effect of a ionizer... you'll detect from far.
EM emission is detected from corona. The like happens with power lines, running at hi-voltage 100Kv or more, enormous detection.

But buried gold ? What has to do with hi-freq. magnetic field ???

For me have no sense at all.

Kind regards,
Max

[Max]

Hi Esteban
So the energy is very strong and this is the phenomenon that we must looking for ???????
Regards


The energy is very strong in treasure sites. I can comprobe in one opportunity, without doubdt, with a not very sensitive device.

I build a square aluminium loop, medium size, 60X60 cm, and insert in it a ferrite core with near 30 ohms of resistence, thin wire. Connect to simple electronics. This is only when you're over the treasure or very near of it. So, is a passive absorptive device of energy.


Btw .... do you received an email from me before somo days ago ?????

Ahh!!! You email me to a corporative Outlook email. Soon I'll email you.

Regards

Esteban

Hi,
I emailed you ? When ?

You are more stressed than me!

I don't.

Kind regards,
Max

[Max]

this is possible, input can be overloaded , hi-impedance etc but seems strange that supposed signal from a buried treasure could burn the input stage of any op. amp. !

In open circuit, yes. No in clossed type coils in MD for example. For your information, THIS OCCURS IN OPEN INPUT SYSTEMS.

Have you the minimum of experience in it? Have you build electronic LRL type open base, for example? What do you know about it? Do you are very young?

Hi,
You are the master of LRL, no dubt about that !
Problem are results...

ehm you want detect water... then detect hi-voltage power-lines ...
Not a good thing if you need to refresh from hot temperature... I mean stay under a powerline.

Thing can run even warmer!

Kind regards,
Max

[Esteban]

But buried gold ? What has to do with hi-freq. magnetic field ???

For me have no sense at all.

Kind regards,
Max

I assure you, the phenomenom is complex. Te object must be buried for X time.

And this is valid for copper, nickel (coins based in copper-nickel alloys), silver, bronze, and expect for platinum. Incredivel, aluminium has some reluctance.

[Esteban]

Hi,
I emailed you ? When ?

You are more stressed than me!

I don't.

Kind regards,
Max


Max,

Is in response to Geo, he wrote. Not very stressed.

[Max]

Hi,
I emailed you ? When ?

You are more stressed than me!

I don't.

Kind regards,
Max


Max,

Is in response to Geo, he wrote. Not very stressed.

I was lost in the mix of messages