Strong signal from Ferrite

[aft_72005]

Ok,if Geo put his L rods p00p box generator here in forum,i also can put this one made long time ago.
It beeps when find target. Patent not registrated

MFD with probes,Generator,Alarm system with Buzzer,Single Rod Antenna... [ATTACH]7218[/ATTACH]

[ATTACH]7219[/ATTACH]

[ATTACH]7220[/ATTACH]

Hi Morgan
Inside of receiver, you use ferrite with coil plus battery and
Small circuit . Why?
Please upload receiver circuit. Also more explain.
Best regards .

[aft_72005]

Before some years i had a schematic with a 555 to drive a coil at VLF.The coil was externally of the axis of the rod. It seems about the same with Morgan's LRL rod. If i will find, i"ll attach it
Regards

Hi Geo
I impatient , seeing circuit diagram.
Best regards.

[Geo]

Geo στειλτω και σε μενα.....

Καλως το παιδι.
Ειναι αυτο που εψαχνα χθες στον υπολογιστη και δεν το βρηκα. Εαν το πετυχω καπου θα στο στειλω

[Geo]

Hi Geo
I impatient , seeing circuit diagram.
Best regards.

Hi Aft...
I have long time to see it
If i will find it, i"ll post it here. But for me, use simple rods in bearings and you are OK

[aft_72005]

Thanks for pictures , did you built the carl MFD and test it on a long range target?

Hi Great Alex
I built Carl MFD some years ago. For test, put some old silver coin
In the ground and behind it at soil. Apply 8.7 kHz sine wave with 20vpp
To ground probe . Carl did use 7.8khz , but I read at old geotch forum that
Esteban Said, correct frequency for silver is 8.7 kHz.
For transmitter I use 10 MHz Philips function generator.
Sometimes I feel that the two Lrods mention to silver coins and sometimes
I didn’t that feel. Sometimes I feel that the two Lrods, crossover on target
Location. And sometimes nothing any . I was astray in the matter.
Also I read more times at forum which Lrods , didn’t work . Then I stopped
My examination with Lrods. Until yet , Geo said me , MFD working .
Also Morgan picture show , he found some coins .
Best regards.

[Geo]

For silver coins, play between 8.7 and 9.2 Khz. Put a silver coin at a place 10..15 cm in the ground and adjust the frequency where the rods close exactly up of the coin.
Regards

[aft_72005]

Ok, Geo, please explain about ferrite electrostatic LRL .
Best regards.

[Qiaozhi]

Also Morgan picture show , he found some coins

I also saw that photo, and the implication is that these coins were found with the LRL / dowsing rod contraption. However, I expect the final recovery was done with a real metal detector.

[Geo]

Hi.
Today i went again at the same place with the generator, L rods and the
electrostatic field detector. Today the detector did not gave me any signal, except a small signal at a point 10m from the point that the rods indicate that there is the treasure. After few days i"ll go again with metal detectors to find the exact point that there is (If there is ) the treasure, and of course to see if the electrostatic field is from gold, or not.
I will inform you for everything
Regards

[sweatofglory]

hello

Hi Geo

why is it mfd detection prone to error? is it because the frequency being used is not fine tuned to that particular metal? many times i dug holes only to find volcanic rock, corals and even trash metals.

[Morgan]

Antenna Rod

I also saw that photo, and the implication is that these coins were found with the LRL / dowsing rod contraption. However, I expect the final recovery was done with a real metal detector.

Antenna Rod it was used to locate the targets in the range not far from the Carl MFD,and then to pinpoint i use one normal metal detector,and i found also a lot of trash,but always something...
This kind of Dowsing devices are very good for playing and finding something,but for those who ask big money for this kind of GIZMOS its unfair.
I asume here,THIS IS ONE ELECTRONIC DOWSING DEVICE.

[Geo]

Hi Geo

why is it mfd detection prone to error? is it because the frequency being used is not fine tuned to that particular metal? many times i dug holes only to find volcanic rock, corals and even trash metals.

Some times when the target is very big and heavy, we have the Ring phenomenon. One way to reduce it is to work at very hight harmonics. So for gold i work also at 630.980.610 Hz. Yesterday all frequencies indicated me about the same point. So it is something and not so big.

[rospy]

For gold i work at 6,20 KHz ''Geo'' and for me is the best ...............

frequency

Here is my generators

1-

2-

3-


Circuits...........Later.

[Great_Alex]

the gold frequency that you are used are so diffrent

630.980.610 Hz = 631Mhz & 6,20 KHz of Geo , 59.5 Khz of Steban device &

i don't understand what's the correct frequency , maybe it response to each frequency

Originally posted by AFT :
ometimes I feel that the two Lrods mention to silver coins and sometimes
I didn’t that feel. Sometimes I feel that the two Lrods, crossover on target
Location. And sometimes nothing any . I was astray in the matter.

i have similar experience with Gravitator ,sometimes it works very well but sometimes detect nothing .

but the explorer always detects the coin

[sweatofglory]

TROUBLED WITH RINGS

I guess you are right GEO! just yesterday, i went also to my site and found out that the two readings using my improvised MFD turned out to be one reading which is located at the center of the two previously detected spots. the distance between the two readings(NORTH & SOUTH) is 24 feet and my previous computation of the depth of the treasure is at 12 feet. i thought the real object is in the north spot! Thank you very much for the clarifications on this matter.



sweatofglory